Euro Cyano Multipurpose Adhesive PROWORK

• For best performance, the surfaces to be bonded must be clean, dry and free of oil or grease.
• This product performs best in small gaps (0.05mm).
• Apply the adhesive on one part. Join and hold pressure for a few seconds.
• The use of accelerator is required for porous surfaces or where there are voids. Some plastics require the use of a Magmont polarizer.
• The product is usually applied directly from the bottle, although it can be applied with the use of cannulas.
• Cyanoacrylate adhesives that are already cured can be removed from most surfaces and disassembled parts with Magmont cleaner. It is not possible to completely remove the cyanoacrylate that is in the tissues. The cleaner is not suitable for the eyes.

• Store the product in its respective container, closed and in a cool, dry place out of direct sunlight.
• Storage between 2ºC and 7ºC gives it optimum stability. Storage below 2ºC or above 7ºC may adversely affect product properties. The material removed from the container may become contaminated during use. Do not return the excess product to the original container. Castell Universal cannot assume any responsibility for the product that has been contaminated or stored in conditions other than those previously indicated. If additional information is needed, please contact the Technical Department.

Cyanoacrylate is dangerous, it sticks to skin and eyelids in seconds. Keep out of the reach of children. Do not ingest or breathe its vapors. Avoid contact with skin and eyes with proper use of suitable gloves. In case of contact with the eyes, rinse immediately with plenty of water and seek emergency medical attention. In case of ingestion, the product immediately polymerizes in the mouth, making it impossible to swallow, but watch out for the risks of drowning. For more information on accidental ingestions call the Toxicological Information Service at 91 562 04 20 or consult the safety data sheet.